|
|
|
Boxes, Grommets & Seals
|
|
For location on a desk or counter. Designed to allow one patchcord through & to house the patchcord before use. The grommet lid has a clip on the underside that allows the patchcord to be hooked on. The grommet requires a 30mm diameter hole and can acommodate a solid 25mm conduit for a fixed installation if required. Ideal for chip and pin installations. |
|
Consists of an outer flange and a two part insert. the outer flange fits into an 80mm hole. Cable are then passed through and the insert fitted with the appropriate quantity of holes exposed.
Standard Colour : Grey or Black |
|
Consists of an outer flange and a two part insert. The outer flange fits into an 95mm hole. Cables are then passed through and the insert fitted with the appropriate extent of slot revealed
Standard Colour : Grey or Black
|
|
Consists of an outer flange and a two part insert. the outer flange fits into an 127mm hole. Cables are then passed through and the insert fitted. Available with either three holes of a slot.
Standard Colour : Grey or Black
|
|
The air-guard GTAG1 provides a cableway 230 x 65mm and assists optimising the thermal management of the data room plenum through the raised floor installation. This device has a removeable section to allow easy cable release. |
|
The air-guard GTAG2 provides a maximum cableway 180 x 120mm through an upper brush and lower gasket section. It fits into a 230 x 175mm opening in the raised floor. The unit comes with a safety cover which can be removed when cables are installed. |
|
The air-guard GTAG3 provides a cableway 200 x 200mm. Unlike the GTAG1 this unit sits upon the raised floor so is ideal when retrofitting existing holes upto 200 x 200mm. This unit can also be use as two seperate perimeter seals.
|
|
A solid grommet for a new cable installation, providing a 203 x 102mm cable hole.
Used to reduce airflow from the floor void by offering a form of seal. |
|
A split grommet for a new or retrofit cable installation, providing a 203 x 102mm cable hole.
Used to reduce airflow from the floor void by offering a form of seal.
|
|
A raised grommet for a new or retrofit cable installation, providing a 203 x 102mm cable hole.
Used to reduce airflow from the floor void by offering a form of seal.
|
|
The hive is a complex product providing the facility to lock into the floor panel. Providing a foam packaged passage for cable to access the void below. Available in two sizes 127mm & 210mm.
Standard Colour - Grey
From £26.00 £30.55 (incl VAT)
|
|
|
|
Circular floor boxes with internal plate options to fit data or power devices. |
|
A number of 2, 3 & 4 compartment boxes with combinations of power, data and blank spare sections |
|
|
|
|
|
Terms & Conditions | Privacy
Site Map |
|
 |
© Copyright 2006-2010 IntroDelta Limited. All rights reserved.
IntroDelta: Suppliers of data and communication products including cable management, data cabinets, pdu's, braided sleeve, cable matting, flexible conduit, data boxes and floor grommets.
